Profile cutter wanted,

[unlimitedpower]

Is there anyone on here that is able to cut me out a flange in 8-10mm alloy if i provide them with a gasket,

Im not to clued up on this stuff so don't know what is best to use water laser gas etc etc.

Its only about half the size of a $5 note so quite small,

Willing to pay what ever is the normal rate. Just thought id ask on here before going to the phone book.

Brett

[120y_fj]

i work at a laser cutting place to bad your not in auckland could of done it for you

and most likely 8 or 10mm ali would be water cut

[unlimitedpower]

I don't care where i have to post it to,

[DJZ]

What is it? I can cut one out on the mill for you.

[unlimitedpower]

Its a IACV flange so i can mount a IACV on my intake manifold and then have some sort of idle control,
Do you want to PM me the address then i can send it down to you,

Thanks
Brett