New Zealand Datsun Club

Got some rust converter over everything this weekend plus inside A pillars and front of chassis. Will put cavity wax in these areas after front is painted.

I wouldn't bother cavity waxing the front until the whole car has been painted if you are doing it in a spray booth. If you cavity wax before hand, it can go runny again while on the bake cycle in the booth and either pool in the lowest point or run out of any drainage holes. Just a heads up

Yep good call, am going to have crack at painting it at home

Got this in primer, been doing a little bit of sanding as time allows

Back to black

Been trying to find new subframe bushes for the last month. All I’ve managed to get so far is sway bar bushes and two washers for the front of the subframe not sure what to do next

The trouble with what I have is I am not the first guy in here by the looks


The front round bushes are miss-matched and have a grinder cut down each side to get them to fit the hole. These are 55mm round by 38mm deep. One of the square blocks for the back has been hand crafted out of something and while it looks the same size on the bench when put into the subframe it sits at least 5mm higher
This block is 62mm by 74mm





So yeah that would explain the banging when hitting larger bumps and the sometimes vague/unpredictable steering.
So I guess good second hand is the best bet at this point, perhaps 330 Cedric might have similar bushes. If anyone has something please let me know

Can you buy rubber in blocks from like para rubber etc - may be able to make your own new ones. Ive answered your help listing as ive got spare 330 260c parts and that sub frame looks suspiciously the same.

Been putting things back together. Taken alternator and starter to auto sparkie for an overhaul, had the brake master cylinder overhauled, I left the remote brake booster with them to but they said they couldn’t get a kit for it and never seen one before which sucks

Have also painted the bits of the front subframe that I can’t get to when it’s bolted in and modified the stray rear bush to sit in level with the other side may have to end up using it yet

Quiet weekend, dragged these out and gave them a clean up and that’s about it

Will probably look at a few jobs on the engine this week. Still have the dash to put into the car but need to figure out the vacumn controlled heater/cooling a bit