Wiring in a rev counter

Post Reply
User avatar
Datsun Driver
Posts: 280
Joined: Tue Jul 26, 2011 9:04 pm
Location: Tauranga

Wiring in a rev counter

Post by buzzy » Tue Nov 21, 2017 8:58 pm

Quick question regarding wiring in a factory rev counter. With the ignition wire do I have to cut the wire and join each end of the wire to the rev counter wires so this makes one circuit, or can I just strip the ign wire slightly and solder the rev counter wires on with out cutting the ign wire? Sorry if it is a dumb question but have been told both way are ok but not keen on frying my wiring if i do it wrong...

Datsun God
Posts: 2016
Joined: Fri Jul 18, 2008 10:31 pm
aka: Dan
Location: Christchurch

Re: Wiring in a rev counter

Post by datsunboy » Thu Nov 30, 2017 10:32 pm

Usually you run it through a loop at the back.
Don't cut it or strip it

Sent from my SM-G930F using Tapatalk
1969 SSS Nissan Bluebird coupe
1970 Datsun 1600 - CA18DET - Sold!

Post Reply