Page 1 of 1

Wiring in a rev counter

Posted: Tue Nov 21, 2017 8:58 pm
by buzzy
Quick question regarding wiring in a factory rev counter. With the ignition wire do I have to cut the wire and join each end of the wire to the rev counter wires so this makes one circuit, or can I just strip the ign wire slightly and solder the rev counter wires on with out cutting the ign wire? Sorry if it is a dumb question but have been told both way are ok but not keen on frying my wiring if i do it wrong...

Re: Wiring in a rev counter

Posted: Thu Nov 30, 2017 10:32 pm
by datsunboy
Usually you run it through a loop at the back.
Don't cut it or strip it

Sent from my SM-G930F using Tapatalk