Wiring in a rev counter

Post Reply
User avatar
buzzy
Datsun Driver
Posts: 280
Joined: Tue Jul 26, 2011 9:04 pm
Location: Tauranga
Contact:

Wiring in a rev counter

Post by buzzy »

Quick question regarding wiring in a factory rev counter. With the ignition wire do I have to cut the wire and join each end of the wire to the rev counter wires so this makes one circuit, or can I just strip the ign wire slightly and solder the rev counter wires on with out cutting the ign wire? Sorry if it is a dumb question but have been told both way are ok but not keen on frying my wiring if i do it wrong...
datsunboy
Datsun God
Posts: 2016
Joined: Fri Jul 18, 2008 10:31 pm
aka: Dan
Location: Christchurch
Contact:

Re: Wiring in a rev counter

Post by datsunboy »

Usually you run it through a loop at the back.
Don't cut it or strip it

Sent from my SM-G930F using Tapatalk
1969 SSS Nissan Bluebird coupe
1970 Datsun 1600 - CA18DET - Sold!
Post Reply